Battery specially used for SuperBird VTOL power
Typically hovering time is 2.5 mins
Specification:
Name：4S1Pbattery
Type：Li-po battery
Discharge rate：75C
Voltage：14.8V
Limited capacity：1550mAh/22.9Wh
Fully charged voltage：16.8V
Size: 37*29*72mm
Weight：170g
Attention
Please read the following instructions carefully before charging or using.
Lithium polymer batteries are active substances. If you do not carefully read the following instructions, directly charge or discharge batteries in confined Spaces such as rooms, garages and cars, it may cause fire, personal injury or property loss.
TATTU manufacturers, distributors and dealers are not liable for any accident caused by failure to read TATTU carefully.
In purchasing TATTU products, the Buyer assumes all risks associated with that product. If you do not agree to these terms, please return the battery to the manufacturer immediately before you use it.
Matters needing attention:
Before charging/discharging:
Check whether the battery surface is damaged. Do not charge any damaged battery.
Please check whether the battery is expanded. Do not charge the expanded battery.
Check whether the battery leaks. Do not charge the battery.
Check whether the voltage of each cell of the battery is normal. If the voltage of each cell is lower than the normal voltage (3.3V/cell) or the battery string does not deceive the telecom about the voltage imbalance, the battery has a quality problem. Do not charge the secondary battery.
Please confirm whether the positive and negative terminals of the battery connection are correct. Do not short-circuit the battery.
When charging/discharging:
Do not use nickel cadmium (NICD), nickel metal hydride (NIMH) or other battery chargers to charge lithium polymer (LIPO) batteries.
Do not charge without being watched.
Do not overcharge (the fully charged voltage of each cell shall not exceed 4.25V).
Do not short-circuit (connect positive and negative terminals to reverse).
Please charge in 0-45℃ temperature.
When charging, please note that the charging table or platform can withstand heat and high temperature. When charging, choose to charge in cement or sand flowerpot conditionally.
At no time should the battery core be overheated. After the temperature of the cell is as high as 60℃, there will be safety risks and even combustion.
When charging, the battery should be kept away from or placed directly in flammable materials such as paper, plastic, carpet, vinyl, leather, wood, or placed directly in the device for charging.
Do not overdischarge (the discharging voltage of each battery cell shall not be less than 3.3V). Overdischarge may damage the battery, such as swelling.
Do not splash the electrolyte into eyes or skin. In case of accidental splash, wash the electrolyte with water immediately. In serious cases, seek medical advice immediately. Do not disassemble the battery or change the wiring at will.
Do not contact the battery directly.
Do not assemble batteries without permission. It is dangerous to disassemble old battery cells and reassemble them, or to combine a disassembled cell with another battery group (no special assembly equipment has caused short circuit combustion).
If there is a collision during use, please remove the battery. Check the battery and connector carefully, just in case. Note: Batteries may be hot!
Battery storage:
Please point the battery close to liquid, and do not store the battery in a damp place.
Do not place the battery near an open flame or a heater.
Please keep the battery out of reach of children.
Please make sure the battery is stored in the greenhouse: 25 degrees Celsius.
Make sure the battery has enough storage space (the battery is not pressed against each other).
If the battery is not used for a long time, the storage voltage should be controlled between 3.8V and 3.85V. In addition, please check the battery storage box every two weeks to see if there is any abnormality, and activate it every two months to maintain the stability of the battery.